YONGHESHENG — Reliable Cable Insulation & Sheathing Compounds

Technical Data

Technical Specifications

Typical physical property data, subject to batch test reports.

No.Test ItemsUnitTypical Value (YHS-4251N-1)
1Appearance-Compliance
2Densityg/cm³1.38
3Shore HardnessA85±2
4Tensile StrengthMpa10.0
5Elongation at Break%280
6AgeingTest conditions-158℃*168h
Variation of Tensile strength%+15
Variation of Elongation%-15
7Low-temperature ImpactTest Conditions--40℃
Failure (≤15/30)Piece0
8Oxygen Index%31
9Volume resistivity (20℃)Ω.m3*10¹³
10Dielectric Strength (20℃)MV/m27
11Thermal ElongationTest Conditions-200℃ 0.2Mpa 15min
Elongation under Load%30
Permanent deformation after cooling%0
12pH value-5.5
13Conductivityμs/mm1.1
NoteCan be customized according to customer's requirements.
Recommended

Extrusion Process

Mixing: Mix the A and B Component evenly, drop them into the hopper. Please use EVA masterbatch if color required(it should be dried). The material must be use up within 2 hours after unpacking.(It can’t be dried.)Avoid to bring the external water in during the process.

Screw Type: Equal distance&unequal depth single flight Screw Compression Ratio:1.6±0.2

Pay-off Speed: Without the effect of smoothness and performance, the faster,the better.

Cross-linking: Natural Cross-link:Temperature higher than 25℃,cross-link will be finished around 7days.Water bath or Steam:Control the temperature around 60℃,cross-link will finished about 4hours. (the thickness of the test piece is 1mm) Full performance test,water bath (steam) 60 ℃, more than 8 hours, ensure the material is fully cross-linked.

Extrusion Temperature:Control the melt temperature of Insulation at 160±10℃ . The extrusion temperature needs to be adjusted according to the actual situation.

MarkZone 1Zone 2Zone 3Zone 4NeckHead
YHS-4251N-1100±10120±10140±10140±10140±10140±10
Packaging & Storage

Packaging and storage

1

  • ①Package:Vacuum packed.
  • ②Storage:Should be stacked on the backing plate in a clean and dry warehouse.
  • ③Valid Period:12 months.