YONGHESHENG — Reliable Cable Insulation & Sheathing Compounds

Technical Data

Technical Specifications

Typical physical property data, subject to batch test reports.

No.Test ItemsUnitTypical Value (YHS-6251-2)
1Appearance-Compliance
2Densityg/cm³1.38
3Tensile StrengthMpa13
4Elongation at Break%300
5AgeingTest conditions-150℃*168h
Retention rate of Tensile strength%115
Retention rate of Elongation%80
Test Conditions-185℃*100h
Retention Rate of Elongation at Break%80
6Low-temperature Impact -40℃,Failure(≤15/30)Piece0
7Oxygen Index%30
8Volume resistivity (20℃)Ω.m3*10¹³
9Dielectric Strength (20℃)MV/m28
10Hot Set TestTest Conditions-250℃ 0.2Mpa 15min
Elongation under Load%40
Permanent deformation after cooling%0
11Acid gas emission during burningHalogen acid gas content%0
pH value-5.1
Conductivityμs/mm1.2
12Smoke DensityFlamingDs max90
Can be customized according to customer's requirements.
⚠️ The data of original elongation at break is tested after the process at 130℃ ×24h.
Recommended

Extrusion Process

Mixing: Mix the A and B Component evenly, drop them into the hopper. Please use EVA masterbatch if color required(it should be dried). The material must be use up within 2 hours after unpacking.(It can’t be dried.)Avoid to bring the external water in during the process.

Screw Type: Suggest to use equal distance& unequal depth,single flight screw. YHS-6251-2 Compression Ratio: 1.5±0.2

Pay-off Speed: Without the effect of smoothness and performance, the faster,the better.

Cross-linking:Natural Cross-link:Temperature 15-25℃,cross-link will be finished around 7days.When temperature is higher than 25℃,cross-link will be finished around 3days.Water bath or Steam:Control the temperature around 60℃,cross-link will finished about 4hours. (the thickness of the test piece is 1mm) Full performance test,water bath (steam) 65℃, more than 8 hours, ensure the material is fully cross-linked.

Extrusion Temperature:Maintain the temperature at 160±10℃. The extrusion temperature should be adjusted according to the actual situation.

MarkZone 1Zone 2Zone 3Zone 4NeckHead
YHS-6251-2100±10125±10135±10135±10140±10140±10
Packaging & Storage

Packaging and storage

1

  • ①Package:Packed by aluminium foil bag.
  • ②Storage:Should be stacked in a clean and dry warehouse.
  • ③Valid Period:12 months.