Technical Specifications
Typical physical property data, subject to batch test reports.
| No. | Test Items | Unit | Typical Value (YHS-6251H) | |
|---|---|---|---|---|
| 1 | Appearance | - | Compliance | |
| 2 | Density | g/cm³ | 1.5 | |
| 3 | Tensile Strength | Mpa | 12.0 | |
| 4 | Elongation at Break | % | 180 | |
| 5 | Ageing | Test conditions | - | 150℃*168h |
| Retention rate of Tensile strength | % | 120 | ||
| Retention rate of Elongation | % | 80 | ||
| Test Conditions | - | 185℃*100h | ||
| Retention Rate of Elongation at Break | % | 75 | ||
| 6 | Low-temperature Impact - 40℃,Failure(≤15/30) | Piece | 0 | |
| 7 | Oxygen Index | % | 35 | |
| 8 | Volume resistivity (20℃) | Ω.m | 1*10¹² | |
| 9 | Dielectric Strength (20℃) | MV/m | 25 | |
| 10 | Hot Set Test | Test Conditions | - | 250℃ 0.2Mpa 15min |
| Elongation under Load | % | 35 | ||
| Permanent deformation after cooling | % | 0 | ||
| 11 | Acid gas emission during burning | Halogen acid gas content | % | 0 |
| pH value | - | 5 | ||
| Conductivity | μs/mm | 1 | ||
| 12 | Smoke Density | Flaming | Ds max | 85 |
| Can be customized according to customer's requirements. |
Extrusion Process
Mixing: Mix the A and B Component evenly, drop them into the hopper. Please use EVA masterbatch if color required(it should be dried). The material must be use up within 2 hours after unpacking.(It can’t be dried.)Avoid to bring the external water in during the process.
Screw Type: Suggest to use equal distance& unequal depth,single flight screw. YHS-6251H Compression Ratio: 1.5±0.2
Pay-off Speed: Without the effect of smoothness and performance, the faster,the better.
Cross-linking:Natural Cross-link:Temperature 15-25℃,cross-link will be finished around 7days.When temperature is higher than 25℃,cross-link will be finished around 3days.Water bath or Steam:Control the temperature around 60℃,cross-link will finished about 4hours. (the thickness of the test piece is 1mm) Full performance test,water bath (steam) 65℃, more than 8 hours, ensure the material is fully cross-linked.
Extrusion Temperature:Maintain the temperature at 160±10℃. The extrusion temperature should be adjusted according to the actual situation.
| Mark | Zone 1 | Zone 2 | Zone 3 | Zone 4 | Neck | Head |
|---|---|---|---|---|---|---|
| YHS-6251H | 100±10 | 125±10 | 135±10 | 135±10 | 140±10 | 140±10 |
Packaging and storage
- ①Package:Packed by aluminium foil bag.
- ②Storage:Should be stacked in a clean and dry warehouse.
- ③Valid Period:12 months.


