Technical Specifications
Typical physical property data, subject to batch test reports.
| No. | Test Items | Unit | Typical Value (YHS-1254G) | |
|---|---|---|---|---|
| 1 | Appearance | - | Compliance | |
| 2 | Density | g/cm³ | 1.72 | |
| 3 | Tensile Strength | Mpa | 11.0 | |
| 4 | Elongation at Break | % | 180 | |
| 5 | Ageing | Test conditions | - | 158℃*168h |
| Variation of Tensile strength | % | +15 | ||
| Variation of Elongation | % | -15 | ||
| 6 | Low-temperature Impact | Test Conditions | - | -40℃ |
| Failure (≤15/30) | Piece | 0 | ||
| 7 | Oxygen Index | % | 49 | |
| 8 | Volume resistivity (20℃) | Ω.m | 1*10¹² | |
| 9 | Dielectric Strength (20℃) | MV/m | 25 | |
| 10 | Hot Set Test | Test Conditions | - | 200℃ 0.2Mpa 15min |
| Elongation under Load | % | 35 | ||
| Permanent deformation after cooling | % | 0 | ||
| 11 | pH value | - | 5.1 | |
| 12 | Conductivity | μs/mm | 1 | |
| 13 | Smoke Density | Flaming | Ds max | 50 |
| Non-Flaming | Ds max | 240 | ||
| Can be customized according to customer's requirements. |
Extrusion Process
Mixing: Mix the A and B Component evenly, drop them into the hopper. Please use EVA masterbatch if color required(it should be dried). The material must be use up within 2 hours after unpacking.(It can’t be dried.)Avoid to bring the external water in during the process.
Screw Type: ②Screw Type: Suggest to use equal distance& unequal depth,single flight screw. Compression Ratio: 1.6±0.3
Pay-off Speed: Without the effect of smoothness and performance, the faster,the better.
Cross-linking:Natural Cross-link:Temperature 15-25℃,cross-link will be finished around 7days.When temperature is higher than 25℃,cross-link will be finished around 3days.Water bath or Steam:Control the temperature around 60℃,cross-link will finished about 4hours. (the thickness of the test piece is 1mm) Full performance test,water bath (steam) 65℃, more than 8 hours, ensure the material is fully cross-linked.
Extrusion Temperature:Control the melt temperature of Insulation at 160±10℃. The extrusion temperature needs to be adjusted according to the actual situation
| Mark | Zone 1 | Zone 2 | Zone 3 | Zone 4 | Neck | Head |
|---|---|---|---|---|---|---|
| YHS-1254G | 100±10 | 125±10 | 135±10 | 135±10 | 140±10 | 140±10 |
Packaging and storage
- ①Package:Packed by aluminium foil bag.
- ②Storage:Should be stacked in a clean and dry warehouse.
- ③Valid Period:12 months.

