Technical Specifications
Typical physical property data, subject to batch test reports.
| Properties | Unit | Test method | Index | Typical Value |
|---|---|---|---|---|
| Tensile strength | MPa | IEC 60811-501 | ≥ 10.0 | 12.4 |
| Shore Hardness | Shore A | ISO 868 | 90±3 | 91 |
| Elongation at break | % | IEC 60811-501 | ≥ 160 | 180 |
| Heat-aged experiment (100℃×168h) | IEC 60811-401 | |||
| Max change rate of tensile strength | % | IEC 60811-501 | ±25 | +9 |
| Max change rate of elongation at break | % | IEC 60811-501 | ±25 | -12 |
| Low temperature brittleness | ℃ | ISO 974:2000 | -30 | Pass |
| Volume resistivity (20℃) | Ω·m | IEC 60811-501 | ≥1.0×10¹² | 3.0×10¹² |
| Dielectric strength (20℃) | kV/mm | IEC 60243-1:1998 | ≥ 20 | 23 |
| Oxygen index | - | ISO 4589-2 | ≥ 28 | 35.5 |
| Thermo-shock test (150℃×1h) | - | IEC 60811-406 | No cracking | No cracking |
| Density | g/cm³ | ISO 1183-1:2004 | 1.20-1.55 | 1.47 |
| PH value | IEC 60754-2 | ≥ 4.3 | 6.0 | |
| Conductivity | μS/mm | IEC 60754-2 | ≤ 10 | 1.1 |
| Smoke density (with flame) | - | ISO 5659-2 | ≤ 100 | 88 |
| Melt Flow Index (@21.6kg and 150℃) | g/10min. | ±0.5 | 4.0 | |
| Eco-friendly requirement | - | - | Comply with RoHS & REACH | Pass |
Extrusion Process
It can be manufactured by PVC extruder (L / D ≥20) , extrusion rate is equivalent to PVC processing. wire products must have smooth surface, visual fine, uniform diameter ,crosssection tight and have no porosity.
If you use a low compression ratio of the screw (that is usually called halogenfree special screw, or elastomer extrusion screw), should be based on the specific circumstances to use filter plates and filter combinations in order to generate a suitable back pressure .
Extruder heating and cooling system must be able to run normally, the temperature can be automatically controlled in order to avoid melt temperature exceeding.
This product is hygroscopic, so use aluminumplastic film for package and can be used directly, it should be predried and preheated at 60℃ ~ 70℃ if it is possible. If stored too long or the bag leaks, it must be
As the difference of structure and speed, the temperature setting may be adjusted in order to achieve the optimization.
| Mark | Zone1 | Zone2 | Zone3 | Zone4 | Zone5 | Zone6 | Head | Die |
|---|---|---|---|---|---|---|---|---|
| 125℃ | 135℃ | 140℃ | 145℃ | 150℃ | 150℃ | 160℃ | 160℃ |
Packaging and storage
- Packing: 25kg/bag, with Composite aluminumplastic integrated selfexhaust bag packaging.
- Transportation: it should be protected from direct sunshine, rain and moisture during transportation.
- Storage: keep in clean, dry and ventilated warehouse.


